Parrot ASTEROID Smart Bedienungsanleitung Seite 16

Connecting the parking brake lead
The parking brake lead allow s you to use the
Parrot ASTEROID Smart video function or
applications only w hen the parking brake is
set. If this cable is not connected to your
vehicle parking brake system, the video
function w ill not be available.
1. Connect the parking brake extension lead
to the Parrot ASTEROID Smart green
cable.
2. Locate the parking brake signal cable of
your vehicle.
3. Install the Parrot ASTEROID Smart parking
brake extension lead and the parking
brake signal cable on the provided crimp
connector.
4. Fold the crimp connector tw ice (diagram
A p.7).
Warning: An improper connection or use of this
cable is dangerous and illegal in many states.
Installing a rear view camera
If you are to use the Parrot ASTEROID Smart
16 English
w ith a rear view camera (not provided), the
orange cable on the Parrot ASTEROID Smart
ISO cable w ill detect w hen the gearstick is
moved to "reverse". Connect this cable to the
one providing pow er to the rear light of your
vehicle in order to display the rear view
camera image w hen backing your vehicle.
Connect the rear view camera video cable to
the Video CAM connector located at the back
of the Parrot ASTEROID Smart.
Installing the microphone
We recommend that you slide the cable into
the groove behind the door seal.
If the cable runs above the pedals, ensure
that it is properly secured.
Warning: Do not run the microphone cable
through the heating, ventilation or
conditioning systems or in front of the side
airbags.
Make sure the microphone is installed as
close to the mouth of the user as possible.
The ideal distance is 60 cm. The best possible
location for the microphone is near the rear-
view mirror.
The microphone needs to be pointed tow ards
the user.
ISO cable connection
Connect the audio and pow er connectors of
the Parrot ASTEROID Smart to the ones of
your vehicle.
Note: Use the provided cable ties to make sure
the cables are well fixed to the car stereo. Insert
one of the cable ties into the slots in the top of
the back of the car stereo (refer to the diagram
p.4).
Once the connections are made, check your
installation. To do so, turn the ignition on then
off. The "Goodbye" message must
displayed. If it is not the case, it is necessary
to sw ap the positions of the red and yellow
w ires. Indeed, the red w ire of the pow er
air
cable must be connected to the 12V ignition,
the yellow w ire to the permanent 12V and the
black w ire to the ground. This can be done
simply by reversing both fuse holders located
on the Parrot w iring.
be