Fagor CI9-20 Allgemeine Bedienungsanleitung Für Installation, Gebrauch Und Wartung Seite 14

The positioning and electrical and gas installation should always be carried out by an AUTHORISED
TECHNICIAN, observing the standards of each country.
•
It is advisable to install an extraction hood for the optimum operation of the appliance.
•
Place the appliance in a well-ventilated place.
•
Level and adjust the height of the appliance. (Fig. 1)
An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a minimum of 3
mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not
fulfilled.
An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a minimum of 3
mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not
fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in
diagram no. 2.
VERY IMPORTANT: Before putting the switchboard top on, fasten the electric supply cable tightly to the
stuffing box.
When several appliances are installed in series, they should be earthed to each other using the point
assigned for this purpose, located in the appliance's base, at the back.
Turning the table plates on
a) Press the power switch situated on the outside of the appliance.
b) Turn the "M" control (Fig. 2) of the switch corresponding to the plate you want to turn on, to the
chosen position or power, and then the "P1" pilot light will turn of (Fig. 2) telling us that the
chosen plate and power are working.
c) Use only cookware that is suitable for induction cookers with a base of at least 12cm diameter
1.-INSTALLATION
Positioning and levelling
Electrical connection
Electrical connection
2.-USE
Turning the appliance on
13