Bebecar spot Gebrauchsanweisung Seite 17

GB
14 - MAIN BUCKLE OPERATION (OPENING): Press simultaneously the two red buttons on the buckle, until
both clips separate from it.
15 - MAIN BUCKLE OPERATION (CLOSING): Join the two clips together, and then fit it into the main buckle,
until it clicks firmly into position (check security by gently pulling in opposite direction).
16 - ADJUSTING BACKREST: The backrest can be adjusted to 3 positions.
Pull up the handle
17 - TO FIT THE HOOD: Clip plastic clamps onto side chassis tube, then rotate it outwards until it makes a click.
You can adjust the height of hood, by simply sliding the hood clamp up or down on the chassis tube.
18 - Unzip the hood zip, to extend the hood size.
19 - Attach back cover to hood by zipping it to main hood.
20 - TO FIT STRAPS TO SEAT COVER: First check the correct position of the two clips of the main buckle (see
figure iii).
i) Start by introducing metal piece (G) into the opening of the seat fabric (A).
Then fit belt (B) into metal piece (G). Check if belt is secure, by pulling the belt.
ii) Then pass rings (D) through seat cover (A).
iii) Pass strap (B) through both rings (D) as indicated by the arrows, verifying that they are not twisted (see
figure) and then enter the other end of belt (B) into the other metal piece (G), following step (i).
iv) Thread crotch strap (E) to seat cover opening, and then place crotch strap (E) inside the protective pad
(C). (see picture)
v) Finally, fasten with press-studs shoulder pads (F) to seat cover belt.
Then apply the shoulder belts (B) into the shoulder pads (F) as shown.
Note: Make sure the belt is under the Velcro strip.
21 - REMOVAL OF SEAT COVERS TO WASH:
NB – First remove harness restraint before removal of seat cover.
a) Remove bumper bar first from chassis and then remove cover of bumper bar.
b) Unfasten the plastic hooks (top and middle) from metal chassis tube.
c) Loosen elastic loop from metal pin at the bottom of seat (see figure).
d) Slide off upholstery from metal legrest, and then loosen Velcro ribbon underneath it.
e) Pull off upholstery from backrest tubes.
Note: To fit the seat fabric follow the steps above in the reverse order.
IMPORTANT - Before washing, refer to the separate washing instructions included with this pushchair.
22 - FOLD PUSHCHAIR:
N.B: Please remember to lock the swivel wheels in the non-steering mode before folding chair.
a) NOTE: First adjust backrest by pulling handle and simultaneously move backrest to the upright position.
b) Then operate secondary lock upwards as indicated, and simultaneously operate primary safety device
lock, by pulling the plastic tab upwards.
c) Then fold chassis until it is completely folded.
d) To lock chassis in the folding position, close the folding latch on side of chassis.
23 - BASKET: To attach the front part of the basket, pass the webbing strap around the legrest of chassis as
shown. Then lock press-studs together. Then close the front part of basket using the Velcro strip. To attach
the rear part of the basket, pass the webbing strap through the plastic ring of the rear leg of chassis as
shown. Then lock press-studs together.
24 - The back part of the hood has pocket for storage. Do NOT overload it - Maximum load 0,5 kg.
situated behind the seat and simultaneously move it to the desired position.