Bebecar spot Gebrauchsanweisung Seite 16

GB
READ THESE INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP THEM FOR FUTURE REFERENCE
YOUR CHILD'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS
WARNING: This pushchair has been designed to be operated as shown in the instructions supplied. Not to do so
may cause damage and render your guarantee void.
1 - TO UNFOLD: With the chassis laid down, undo the folding latch, on side of chassis.
2 - Then lift handle bar until chassis is completely unfolded. To engage the secondary lock, press down firmly
on the plastic pedal at the rear of the pushchair with your foot.
NB: Ensure mechanism is fully locked before using the pushchair.
3 - STEERING - NON-STEERING: The front wheels can be used in either mode. Slide lever (on both sides of
chassis) to the upwards position for steering.
For non-steering wheels press button and lever will slide in a downward position.
NB: When using your pushchair on rough ground we recommend non-steering mode.
4 - BRAKE OPERATION: To apply brake, press down on pedal.
NB: Check that both brakes are locked.
5 - To release brake, raise the pedal.
6 - LEGREST: The legrest can be adjusted to 2 positions.
To lower or lift the legrest, press the button and swing the legrest to the desired position.
7 - BUMPER BAR: This bumper bar shall be placed at all times when a baby is in the
To remove it for washing (purpose only), press as shown in fig. a) and pull to remove the bumper bar from
chassis. To fit, insert ends of bumper bar into slots as shown in fig. b).
8 - TO REMOVE THE REAR WHEEL: Pull knob downwards and at the same time pull the wheel away from the
axle housing.
9 - TO FIT THE REAR WHEELS: Insert axle in axle housing and press inwards.
Check by pulling wheel to confirm latching of the axle.
10 - TO REMOVE THE FRONT WHEEL:
steering button is in the upwards position.
Press side wheel button and at the same time pull the wheel away from the front leg.
11 - TO FIT THE FRONT WHEELS:
the upwards position.
Press button and at the same time push wheel housing into front leg, until it locks into position.
Check by pulling wheel to confirm it is locked in place.
12 - REAR SUSPENSION SYSTEM: Adjustable in two positions. With brakes applied, use foot to make
adjustment.
POSITION "a" – Release suspension moulding as shown in the figure for a soft option for the young infant.
POSITION "b" – Press down on suspension moulding, for a strong but comfortable setting for the larger
child. Always ensure that both suspension mouldings are adjusted to the same level.
13 - HARNESS RESTRAINT: Shoulder adjustment is made by pulling the straps through the adjusters indicated
until a snug fit is obtained. Remember the amount of clothing your child is wearing will affect the fit so check
the adjustment each time the pushchair is used.
First adjust the shoulder straps (A) then the crotch strap (B) and finally the waist straps (C).
NB. "D" rings are located near the bottom of the backrest
harness complying with BS6684.
N.B. The front wheels of this chassis can only be removed if the
N.B. The front wheels of this chassis can only fitted if steering button is in
on the seat, these can be used for an
pushchair.
additional