Rack Installation - LG PCS200R Pro:Centric Handbuch

Typical Rack Installation
1. (Optional) As shipped, the PCS200R mounting brackets are attached flush with the front of
the unit (see diagram a). If desired, the mounting brackets may be detached from the unit
and reattached, for example, so that they are flush with the rear of the unit (see diagram
b). If you wish to change the location/orientation of the mounting brackets, carefully remove
each of the four (M4 x 10 mm) screws and attendant washers (one flat and one lock washer
per screw) holding each bracket in place. Then, use the same screws and washers to reat-
tach the mounting brackets in the desired location.
2. Carefully slide the chassis into a standard 19-inch equipment rack.
3. Use all four mounting screws to secure the chassis to the rack.
(a)
To rack
(b)
SSD (OPTI ONAL
MAXIM UM CURR
ENT +5V DC @ 2.0A
MAXIM UM CURR
PWR
PWR
)
MODEL: PCS200R
RF-OUT DATE: xx/xx/xx
I IIIII IIIIIIII IIIIIIIIIIIIIIIIII
II IIIIIIIIIIIIIIIIIII III
0 dBmV *201-12520 08*
RF-OUT
ASI-O UT
FIRMWA RE VER: Featu re Port
Contro l Port
Rx.x
MAC ADDRES S:
<Eth0>
xx:xx:xx:x x:xx:xx
<Eth1>
xx:xx:xx:x x:xx:xx
SSD (OPTI ONAL
)
ENT +5V DC @ 2.0A
RF-OUT MODEL: PCS200R
DATE: xx/xx/xx
I IIIII IIIIIIII IIIIIIIIIIIIIIIIII II IIIIIIIIIIIIIIIIIII III
0 dBmV
*201-12520 08*
RF-OUT
ASI-O UT Featu re Port
FIRMWA RE VER:
Contro l Port
Rx.x
MAC ADDRES S:
<Eth0>
xx:xx:xx:x x:xx:xx
<Eth1>
xx:xx:xx:x x:xx:xx

Rack Installation

To rack
POWE R
Servic e Port
12V
POWE R
Servic e Port
12V
Use flat washer and
lock washer with each
M4 x 10 mm mounting
bracket screw.
9