Troubleshooting - LG PCS200R Pro:Centric Handbuch

This section provides introductory PCS200R installation and setup troubleshooting
information. Refer to the extended Installation & Setup Guide for additional trouble-
shooting information.
Equipment Setup Review
•
Make sure all connectors and connections are tight and secure on all entertainment
system components.
•
Check the PCS200R LED: Under standard operating conditions, i.e., when the
PCS200R is booted and operating normally, the PWR (Power) LED on the PCS200R
front panel is continuously lit green. If there is a hardware fault, the PWR LED will turn
and stay red.
Note: When power is first applied to the PCS200R, the PWR LED initially flashes red
and then turns green (blinking during boot-up).
Network Setup
If the network is configured for DHCP but the PCS200R has not been assigned an IP
address, i.e., the Ctrl IP field in the PCS200R System Information display is blank:
1. Check the Control Port connector on the rear panel of the PCS200R. Make sure the
cable connection is tight and secure.
2. Observe the green LED on the Control Port. Once the PCS200R is connected to
the network, the LED will be lit continuously.
3. Contact the network administrator to verify the network status and check that the
DHCP server is working properly.

Troubleshooting

19