LG PCS200R Pro:Centric Handbuch Seite 15

(Continued from previous page)
Command > prompt, type info and press Enter. (You can press Enter at any
7. At the
PCS200R command prompt to view current menu, if desired.)
The initial System Information display identifies PCS200R, default configuration
settings, including the Control Port IP address and the output configuration, for example:
PCS200R Pro:Centric Server v6.7
Copyright (c) 2010 - 2014 Zenith Electronics LLC
SN: 201-12301011
Hardware ID: 2
OS version: Linux 3.4.0-zenith-pcs200+
OS release: #112 SMP Mon Aug 19 10:38:49 CDT 2013
Ctrl MAC: 00:0C:63:40:36:14
Ctrl IP: 10.166.60.92
Feat MAC: 00:0C:63:40:36:15
Feat IP: n/a
VPN IP: n/a
RF config: Mode 3, 256-QAM-B, RF: 6 MHz, 5.36 MSps, ASI: 38.81
RF channel: 75
Channels: 1
Local time: Tue May 20 14:42:02 EDT 2014
8. Check the Ctrl IP (Control Port IP address) field in the System Information display. By
default, the PCS200R uses DHCP; thus, the DHCP server, if configured, assigns an IP
address to the Control Port once the PCS200R successfully connects to the network.
•
If the Crtl IP field shows an IP address, the PCS200R is up and running on the
network. If you wish to configure a static IP address for the Control Port and/or if you
need to configure a static IP address for the Feature Port (for IP output purposes),
continue with step 9. Otherwise, you can go to step 10 at this time.
•
If the network is configured for DHCP but the Ctrl IP field is blank, refer to "Network
Setup" troubleshooting information on page 19.
•
If the network is not configured for DHCP, you will need to configure a static IP
address for the PCS200R Control Port as described in step 9.
System Setup (Cont.)
(Continued on next page)
Mbps
15