Beurer EM 26 TENS Gebrauchsanweisung Seite 29

Connecting the connection
cable and positioning the
shoulder cuff
1. Connect the connection cable to
the metallic connection clips on
the shoulder cuff.
Note
Before positioning the shoulder cuff, first clean the body
parts to be treated.
Before positioning the shoulder cuff, first
moisten the water contact electrodes and the
shoulder with water.
Note
The shoulder cuff can be used for both the left and right
shoulder. Important: When putting the belt on, it must al-
ways first go round your back so that you can tighten the
belt at the front.
2. To fit the cuff more easily, first of all fix the bottom end
of the cuff using the hook-and-loop fastener provid-
ed, and slip your arm through the opening in the cuff.
Then use your healthy arm to pull the cuff over your
painful shoulder. You can tighten the hook-and-loop
fastener later once you have closed the belt.
3. Now use your healthy arm to grab the belt behind your
back, pull it to the front, and through the buckle pro-
vided on the shoulder cuff. After this you can fix the
end of the belt directly to the belt itself using the hook-
and-loop fastener.
4. If required, you can now fix the hook-and-loop fasten-
er on your upper arm more firmly.
5. Fix the cuff in the desired po-
sition using the hook-and-loop
fasteners. Ensure that the cuff is
not too tight but that the water
contact electrodes still have suf-
ficient contact with the skin.
6. Insert the plug for the connec-
tion cable into the connector
socket [5] on the control unit.
29