Beurer medical BC 19 Gebrauchsanleitung Seite 17

If this pressure is insufficient, the device automatically
inflates by another 40 mmHg (Real
Fuzzy Logic).
• Then the pressure in the cuff is
slowly released and the pulse is
measured.
• When the measurement has been
completed, the remain ing air pres-
sure is released very quickly. The pulse, the systolic
and the diastolic blood pressure are displayed.
• You can adjust the volume during the announcement
by pressing + and -.
• You can interrupt measurement at any time by pres-
sing the START/STOP button
• 'Er_' appears if it has not been possible to perform the
measurement properly. Observe the section in these
instructions on error messages/troubleshooting and
repeat the measurement.
• The test result is saved automatically.
evaluating results
cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia
disorders during measurement and if necessary indi-
cates the measurement with the flashing icon
• • • • • • • • • • • • •
.
.
This may be an indicator for arrhythmia. Arrhythmia is
a condition where the heart rhythm is abnormal as a
result of defects in the bioelectrical system controlling
the heart beat. The symptoms (omitted or premature
heart beats, slow or excessively fast heart rate) may be
caused, among other things, by heart disease, age, phy-
sical predisposition, excessive use of stimulants, stress
or lack of sleep. Arrhythmia can only be ascertained
through examination by your doctor.
Repeat the measurement if the flashing icon
displayed after the measurement. Please note that you
should rest for 5 minutes between measurements and
not talk or move during the measurement. If the icon
appears often, please contact your doctor. Any
self-diagnosis and treatment based on the test results
may be dangerous. It is vital to follow your doctor's
instructions.
WHO classification:
According to WHO Guidelines/Definitions and the
latest findings, the test results can be classified and
evaluated according to the following chart:
17
is