Gewiss GW 10 793 Handbuch Seite 52

OPERATING INSTRUCTIONS
WARNING: For fan coil speed control with ON/OFF type
commands, if there is no actuator with interlock, enabling
notifications from the controlled actuator and object link for
ETS project configuration is recommended. In this case (for
example, when switching from V1 to V2) the thermostat
sends a start V2 speed command only after receiving
notification on V1 speed command contact opening (switch
from speed OFF). Without notification, the thermostat
repeats the contact opening command until it receives a
positive response. This condition is signalled on the display
by the blinking
the stalemate condition, simultaneously press the FAN key
and the central
P06 - Setting the cycle time
When the P06 code appears on the screen, set the cycle
time using the
The values available are as follows: 5, 10, 20, 30, 40, 50,
60 minutes.
It is possible to set different cycle times for the heating and
air-conditioning functions.
Press the
P07 - Setting the proportional regulation differential
value
When the P07 appears on the display, set the differential
regulation value using the
Possible values from 0.4 °C to 3.2 °C, with a pitch of
0.4 °C.
It is possible to set different regulation differentials for the
heating and air-conditioning functions.
Press the
If a 1 bit value has been selected as the control value when
configuring with ETS, move on to NOTE 1, otherwise move
on to point P08.
symbol. If the condition persists, to exit
key for 5 seconds.
keys.
key within 30 seconds to confirm the value set.
keys.
key within 30 seconds to confirm the value set.
52