Electrolux EDI97170W Benutzerinformation Seite 13

steam phases are shown by animated
clouds of steam.
Caution! Important: During the steam
phases that form part of the Iron Aid
programme and also the anti-crease
phase (represented by animated clouds
of steam in the display), the loading door
cannot be opened. Risk of burns!
If the water tank indicator lights up when
you select an Iron Aid programme, the pro-
gramme cannot be started. You will need to
fill the water tank first (see section on 'Clean-
ing and maintenance,filling water tank'.)
It is normal for the appliance to make
noises during an Iron Aid or drying pro-
gramme if garments with hard parts,
such as metal buttons, are put in the
drum.
Changing a programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
O OFF and then reset the programme.
The programme can no longer be
changed directly once the programme
has started. If you nevertheless attempt
to change the programme with the pro-
gramme knob or an additional function
button (except the ZOEMER (BUZZER)
button), the START/PAUZE button and
will flash in the display. The drying
programme is not however affected by
this.
Putting in extra items or taking items out be-
fore end of programme
1. Open door.
2. Load or remove laundry items.
3. Close door securely.
4. Press the START/PAUZE button to con-
tinue the drying cycle.
Iron Aid programme complete /
removing laundry
After the Iron Aid phase has ended,
is illuminated and the icon
TICREASE appears in the display. If the
ZOEMER (BUZZER) has been activated, an
audible signal sounds at regular intervals.
The Iron Aid programme is automatically
followed by an anti-crease phase, in-
cluding brief steam phases, which lasts
around 90 minutes.
The drum rotates during the anti-crease
phase. This keeps the laundry loose and free
of creases. It can be removed at any point
during the anti-crease phase, except during
steam phases (look for steam animation in
the display!). Laundry should be removed as
quickly as possible.
1. Open the loading door to remove the
laundry.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See
"Cleaning and maintenance" section.)
3. Remove laundry one garment at a time.
4. Turn the programme knob to O OFF.
Important! After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container
(See section "Cleaning and mainte-
nance".)
5. Close door.
Caution! To retain the effects of the Iron
Aid treatment, clothes must be removed
one garment at a time during the anti-
crease phase and hung immediately on
a clothes hanger to dry (for at least 5-15
mins, depending on fabric and selected
steam level). Do up the buttons and tug
the garment into shape, paying particu-
lar attention to cuffs and seams.
electrolux 13
AN-