Siemens Pointek CLS 300 Kurzanleitung Seite 14

Logical level display
• value when OUT parameter of Discrete
input function block (0) selected
Bar graph
Falling Edge
(Switch Point 2)
0% Application
Range setting
• represents extent to which sensor is covered
• displayed when one of the three following options is selected in Mode 13: the OUT
parameter of the Discrete input function block; or the Primary Value of the Transducer
Block; or the Sensor Value discrete of the Transducer Block
Setup using 3-button keypad
WARNING: It is essential to check settings during the process itself, and confirm
that they are correct, before regular operation commences.
Notes:
• See Quick Reference table on next page for Modes of Operation.
• Ensure HW Write Protection is disabled (Mode 10, page 13).
Initial setup can be carried out prior to mounting into the process, but it is extremely important
to calibrate the unit and adjust the sensitivity on the product itself.
• Flashing digit indicates cursor position.
• Press M to select a mode. Hold M and tap ⇑ to move
backwards.
• To increment or decrement a value, press ⇑ or ⇓.
• To move cursor to the right, press ⇓.
• After editing the least-significant digit, press ⇓ to
store the value.
• To enter a selection (not a numerical value), press M.
Magnet-activated sensor test
Bring the bar magnet supplied close to the test area on the housing. After
approximately 10 seconds, SENSOR TEST SUCCESSFUL, or SENSOR TEST FAILED,
is displayed as rolling text.
Error message display
Please see the full manual for details.
1.
Switch function (open/closed) depends on setting at Mode 24.
Page EN-12 Pointek CLS 300 (standalone) – QUICK START MANUAL
active
communications symbol
up arrow
(switch closed )
1
Rising Edge
(Switch Point 1)
100% Application
Range setting
,
1
added indicator
(Mode 4)
mode
indicator
sensor covered
primary
reading
M
auxiliary
reading
7ML19985QF81