Pelikan Daniel FOXY R-120SB CAR Bedienungsanleitung Seite 2

CONNECTING THE FOXY CAR 1:8 ESC
The speed controller can be connected by soldering the output cables directly
to the motor terminals or with high quality connectors. Always use new con-
nectors, which should be soldered carefully to the cables and insulated with
heat shrink tube.
Use only high quality connectors to connect the ESC to the power pack as well
- 3,5 mm gold plated connectors (Pelikan Daniel #7941), 4 mm (#7946) gold
FOXY CAR 1:8 ESC Layout
Orange motor wire C
Yellow motor wire B
Blue motor wire A
Sensor socket
Connecting to a Sensored Brushless motor
When using a sensored brushless motor, the Blue motor wire A, Yellow motor
wire B and Orange motor wire C of the ESC MUST be connected to the matching
sensored motor A, B, C terminals. It is necessary to connect the Sensor wire to
the "Sensor" socket on the ESC. Do not change the wires sequence.
Input (+) red
Input (-) black
Receiver cable
plated connectors or DEAN-T (#7949) for currents up to 70A and 6 mm (#7945)
or 8 mm (#7948) gold plated connectors for even higher loads.
Plug the UNI servo connector cable of the ESC to your receiver throttle output.
The BEC votage stabilizer of your ESC will feed your receiver and servos from
the power battery pack.
FOXY CAR 1:8 ESC Wiring Diagram
black
Battery
red
FAN cable
Switch ON/OFF
SET button
Connecting to a Sensorless Brushless motor
When using a sensorless brushless motor, the Blue motor wire A, Yellow mo-
tor wire B and Orange motor wire C of the ESC can be connected to the motor
terminals randomly. If the motor runs in the opposite direction, please swap
any two of the three cables between the ESC and motor.
SENSOR cable
blue
Sensor
A
A
yellow
ESC
B B
orange
C
C
Switch ON/OFF
To receiver,
throttle channel
Sensor
Motor