Using The Thermostat; Operation; Configuration - Vimar 20441 Montageanweisungen

6. USING THE THERMOSTAT.

6.1 Operation.

Make the electrical connections and install the appliance .
Select the required function by pressing its associated key; the
parameters will be displayed in blinking mode and they can be
modified with the "–" "+" keys .
Access to the functions to modify the parameters is timed; the
settings are automatically saved at the end of this time or upon
exiting the menu.
If the relay is activated, the
and the symbol when on air conditioning .

6.2 Configuration.

• KEY + KEY
CNF configuration menu selection .
In the CnF configuration menu (accessed after ~ 5 seconds and
after entering the password) it is possible to make the following
settings:
22 - ENGLISH
symbol is displayed when on heating
• PASSWORD.
This is used to set a 3-digit password (from 000 to 250) that
provides access to the configuration menu .
After selecting the CnF menu, press the
+
" " keys you enter the password and press the
If the value is the right one you enter the CnF menu .
Changing the password.
After selecting the CnF menu, proceed as follows:
- press the key and enter the old password;
- using the key scroll through all the menus until you return to
password entry;
– +
- using the " " " " keys, enter the new password and wait for the
timed exit from the menu.
The new password has then been saved .
–
key; using the " "
key .