Panasonic WV-Q169A Montageanleitung Seite 10

Step 8
Follow the procedure according to the model of
the camera to be installed.
<Installing WV-NW484S>
Use the driver bit supplied with the camera
q
to remove the screws that secure the cam-
era enclosure and remove the enclosure
from the camera main body.
IMPORTANT:
• Refer to the Operating inst ructions of the
camera as well.
Perform camera wiring.
w
Align the screw holes of the mounting chas-
e
sis with the 4 mounting screws of the cam-
era main body and tighten them.
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Screws of the main camera body
10
r
q
Mounting chassis
Screw hole
Camera attachment
(supplied with the
camera)
w
Note:
• The mount bracket supplied with the cam-
era is not used.
Mount the camera enclosure on the camera
main body.
<Installing WV-CW504F, WV-CW504S,
WV-NW502S>
Mount the camera attachment (supplied
with the camera) to this chassis.
Use 4 M4-L8 screws (supplied with the
camera) to secure the camera attachment
firmly as shown in the drawing.
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Mounting
chassis
Connect the camera cables.
M4-L8 x4
(supplied with
the camera)