Opex Omation 210 Envelopener Serie Bedienerhandbuch Seite 102

5. Remove and empty the chip bin.
6. Vacuum loose paper chips and debris from the machine.
7. Use a cloth moistened with liquid cleaner to wipe down the exterior of the
machine.
• Use denatured alcohol on areas with stains, if necessary.
- Any non-flammable commercially available cleaning solution may be
used to clean the machine. When cleaning the OPEX Omation Series
™
210 Envelopener
because of the flammable nature of many of these products. There is a
risk of equipment malfunction and/or injury associated with the use of
aerosol cleaners on OPEX equipment prior to the operation of
equipment.
- When cleaning glass and plastic surfaces, use detergent-based
cleaners such as Fantastic™ or Formula 409™. Detergent-based
cleaners are recommended, because they do not cause component
degradation.
A cloth soaked with cleaning detergent or similar material should never be
used to clean an object such as a belt or roller when the belt or roller is being
driven by the system. Use of a cloth or similar material on moving
mechanisms can result in personal injury. If a belt, pulley or similar part
needs to be cleaned, it should be cleaned while stationary or unplugged.
- Wipe dust and debris from the sensors. Debris build-up can cause jams.
Accumulations of dirt and debris can cover sensors, preventing them
from working effectively. This will hinder machine performance.
8. Re-install the chip bin and nip arm cover.
Operation
Omation Series 210™ Envelopener® Operator Manual
®
, DO NOT USE aerosol cleaners or compressed air
CAUTION
OPEX Corporation
51