AEG S92500CNM0 Benutzerinformation Seite 12

12 www.aeg.com
Problem
The compressor
does not start imme-
diately after press-
ing the FROSTMAT-
IC button, or after
changing the tem-
perature.
The temperature in
the appliance is too
low/high.
The temperature in
the wine cellar is too
high.
The temperature in
the freezer is too
high.
Upper or lower
square is shown in
the temperature Dis-
play.
dEMo appears on
the Display.
Possible cause
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
Products prevent that wa-
ter flows into the water
collector.
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
Solution
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
The compressor starts af-
ter a period of time.
Make sure that products
do not touch the rear
plate.
Set a higher/lower temper-
ature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.