Vimar RS10 Installations- Und Benutzerhandbuch Seite 31

RS10
7 . 5 D E F
: Used to take the control unit to the default parameters, press and release the OK button until the display shows 4 dots to confirm the opera-
tion.
7 . 6 C N T :
used to view the number of openings followed by the gearmotor, the first counter A displays the number of absolute operations, the second
counter P displays the operations performed after a reset controlled by the installer. This is shown in the following example:
x6
Pressing the UP button 6 times displays CNT (counter)
Press the OK button, the display shows the letter A (absolute counter cannot be reset) the number that follows should be multiplied by 10000
Press the UP button, the display shows the number to be added to get the total openings performed by the motor: absolute number =
(000*10000)+(7000)= 7000
Press the UP button, the display shows the letter P (partial counter can be reset) the number that follows should be multiplied by 1000
Press the UP button, the display shows the number to be added to get the openings after resetting the partial counter: partial
number = (000*10000)+(1000)= 1000, this means that it was reset on 6000 openings. To reset the partial counter, press
and hold the OK button for at least 5 seconds until the display shows oooo to confirm the operation.
7 . 7 P A SSW O RD :
it is possible to enable a password on 3 levels, with lev el 1 the password is required to enter the PAR, DEF, LRNE and LRN menu,
with level 2 the password is required to enter the RAD menu, with level 3 the password is required to enter all the menu items (LRNE, LRN, DEF, RAD,
CNT, PAR, ERR).
N . B . : If y ou f orget th e passw ord, y ou need to call th e support centre
Example of entering password 4-3-2-1 at the second level:
x8
x4
x4
A password is required every time you try to access the main menu (on pressing the Up or Down button the display will show PASS, you need to enter
the password to display the main menu).
If a password of level 1 or 2 is entered, when you select the protected menu item you will be prompted for the password, enter the password and confirm
with OK, if you exit the menu you will be prompted for the password.
If the password is incorrect the display will show NO.
x5
x2
x3
x3
x2
x2
EN
x1
x1
29