Vimar RS10 Installations- Und Benutzerhandbuch Seite 28

RS10
Starting with the closing limit switch engaged (gate closed), after entering programming mode by pressing the UP, OK, and AP/CH button, the gate
starts opening until the limit switch is engaged. After 2 seconds the gate starts closing at cycle speed, slows down and continues until the closing limit
switch is engaged. The control unit saves the gate travel (the deceleration speed and distance are set as by default).
7 . 2 RA D : remote control management menu is div ided into 4 parameters
D isplay Message D escription
1 C H
Used to save the remote control button corresponding to the
input APCH
2 C H
Used to save the remote control button corresponding to the
input PED or output 2CAN
C T RL
Pressing the button on the remote control lets you compare and
see the memory location where it has been saved.
E RA S
Used to delete a remote control in the memory list or all the
remote controls in the memory.
N.B. The first saved remote control configures the control panel to accept only remote controls with a rolling code or only remote controls with
a fixed 12-bit code.
Note: It is advisable to fill in the final table indicating the number of the memory cell (it is displayed while saving the remote control) in the user
name, th is enab les deleting a remote control sh ould it get lost.
7 . 3 L RN :
Learning travel with custom programming lets you define the points for starting deceleration when both opening and closing:
26
P ressing
1 time up
P ressing
2 times up
P ressing
3 times up
D isplay message af ter activ ating th e remote control
(memory location occupied by the remote control just saved)
(memory location occupied by the remote control just saved)
First character of the display:
- channel associated with the saved remote control button
(1 or 2)
Last three characters of the display:
- memory location occupied by the remote control just saved
1. Press OK until ALL appears on the display. Release OK
To delete all the remote controls:
- press and hold OK until oooo appears on the display
To delete a single remote control:
- scroll with the UP or DOWN buttons until the memory loca-
tion occupied by the remote control which you want to dele-
te, press and hold OK until the display shows oooo (deleting
a remote control from the memory position clears the asso-
ciations of both the first and the second channel)
EN