Maintenance And Cleaning; Cleaning The Sensor - Beko DH 8533 GA0 Bedienungsanleitung

6 Maintenance and cleaning

Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.
A
WARNING!
• Please unplug your product before
performing maintenance and cleaning
instructions. (eg control panel, body, etc.)
6.1 Cleaning Lint Filter / Loading
Door Inner Surface
Lint and fiber released from the laundry to the
air during the drying cycle are collected in the
Lint Filter.
C
NOTE
• You can clean the lint filter housing with a
vacuum cleaner.
A
WARNING!
• Always clean the lint filter and the inner
surfaces of the loading door after each
drying process.
To clean the lint filter:
• Clean lint, fiber, and cotton raveling by
hand or with a soft piece of cloth.
• Close the lint filter and place it back into
its housing.
42
• Open the
loading door.
• Remove the
lint filter by
pulling it up
and open the
lint filter.
• Clean the entire inner surface of the
loading door and loading door gasket
with a soft damp cloth.

6.2 Cleaning the sensor

• Open the loading door of the dryer.
• Allow the machine to cool down if it is still
hot due to the drying process.
• Wipe the metal surfaces of the sensor
with a soft cloth, dampened with vinegar
and dry them.
C
NOTE
• Clean metal surfaces of the sensors 4
times a year.
• Do not use metal tools when cleaning
metal surfaces of the sensors.
A
WARNING!
• Never use solvents, cleaning agents or
similar substances for cleaning due to the
risk of fire and explosion!
A layer can build up
on the filter pores that
can cause clogging
of the filter after using
the dryer for a while.
Wash the lint filter with
warm water to remove
the layer that builds
up on the lint filter
surface. Dry the lint
filter completely before
reinstalling it.
There are
dampness sensors
in the dryer that
detect whether
the laundry is dry
or not.
To clean the
sensors:
Dryer / User Manual