Removing The Transportation Safety Assembly; Connecting To The Drain; Adjusting The Feet - Beko DH 8533 GA0 Bedienungsanleitung

be adversely affected and it can get
damaged.
• The rear surface of the tumble dryer shall
be placed against a wall.
B
DANGER!
Do not place the dryer on the power cable.
* Ignore following warning if your
product's system does not contains
R290.
DANGER!
• Dryer contains R290 refrigerant.*
• R290 is an environment-friendly, but
flammable refrigerant.*
• Ensure that the air inlet of the dryer is
open and it is well-ventilated.*
• Keep potential flame sources away from
the dryer.*
3.2 Removing the transportation
safety assembly
A
WARNING!
Dryer / User Manual
• Remove the
transportation
safety assembly
before using the
dryer for the first
time.
• If the door swing
side of your
appliance can
be modified, see
the reversible
door mounting
instructions.

3.3 Connecting to the drain

You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining the
water collected in the water tank.
Connecting the water drain hose
1 2
3 4
3
Connect one end of the drain hose
supplied with the dryer to the connection
point from where you removed the hose of
the product in previous step.
4
Connect the other end of the drain hose
directly to the wastewater drain or to the
washbasin.
C
NOTE
• Water drain hose should be attached to a
height of maximum 80 cm.
• Make sure that the water drain hose is not
stepped on and it is not folded between
the drain and the machine.
• If there is an accessories pack supplied
with your product, please see the detailed
description.

3.4 Adjusting the feet

1-2 Pull hose at
the behind of
the dryer by
hand in order
to disconnect
it from where it
is connected.
Do not use
any tools to
remove the
hose.
• Turn the feet to
left or right until
the dryer stands
level and firmly.
33