Setting The Remote Camera Operations - Panasonic AW-RP50E Bedienungsanleitung

Setting the functions
 Setting the remote camera 
operations
Set these operations by selecting the [SETUP] menu
followed by the [OPERATE] menu.
[ 4] O P E R A TE
 Setting the pan, tilt, zoom and focus 
operation directions
Set the directions in which the remote camera is to move
when the panning, tilting, zooming or focusing operation has
been initiated from the unit.
Setting the panning direction
From the [SETUP] menu, select [OPERATE] and display
[PAN DIR]. Then select either "NORMAL" or "REVERSE".
1 .P A N D IR
This sets the operation of the remote camera in the
horizontal direction in response to the horizontal
manipulation of the PAN/TILT lever.
When "NORMAL" is selected as the setting, the remote
camera will move to the left when the PAN/TILT lever is
leaned toward the left and, conversely, it will move to the
right when the lever is leaned toward the right.
When "REVERSE" is selected, the remote camera will move
in the opposite directions.
Setting the tilting direction
From the [SETUP] menu, select [OPERATE] and display
[TILT DIR]. Then select either "NORMAL" or "REVERSE".
2 .T I L T DI R
This sets the operation of the remote camera in the vertical
direction in response to the vertical manipulation of the
PAN/TILT lever.
When "NORMAL" is selected as the setting, the remote
camera will move upward when the PAN/TILT lever is leaned
away from you and, conversely, it will move downward when
the lever is leaned toward you.
When "REVERSE" is selected, the remote camera will move
in the opposite directions.
▼
NO RMA L
NO RMA L
Setting the zooming direction
From the [SETUP] menu, select [OPERATE] and display
[ZOOM DIR].Then select either "NORMAL" or "REVERSE".
3 .Z OO M D IR
This sets the zooming operation of the lens in response to
the operation of the ZOOM button.
When "NORMAL" is selected as the setting, the lens zooms
toward the tele end when the TELE side of the ZOOM button
is pressed and, conversely, it will zoom toward the wide end
when the WIDE side is pressed.
When "REVERSE" is selected, the lens will move in the
opposite directions.
Setting the focusing direction
From the [SETUP] menu, select [OPERATE] and display
[FOCUS DIR]. Then select either "NORMAL" or "REVERSE".
4 .F OC US DI R
This sets the focusing operation of the lens in response to
the operation of the FOCUS/PUSH OTAF dial.
When "NORMAL" is selected as the setting, the lens focus
moves toward the far end when the dial is turned clockwise
and, conversely, it will move toward the near end when the
dial is turned counterclockwise.
When "REVERSE" is selected, the lens will move in the
opposite directions.
18 (E)
N OR MA L
N OR MA L