Setting The Black Balance - Panasonic AW-RP50E Bedienungsanleitung

Selecting the settings for a selected remote camera
 Setting the black balance 
The black balance must be adjusted when using a remote
camera for the first time or when the remote camera has not
been used for a prolonged period of time.
It must also be adjusted when significant changes have
occurred in the ambient temperature or at the change of the
seasons.
If the camera is used with the same settings and under the
same conditions, the black balance need not be adjusted
again.
When the black balance is adjusted again, the previous
memory data will be erased and replaced with the new black
balance settings.
When the black balance is set, the R and B pedestal
adjustment settings are returned to ±0.
Automatically adjusting the black balance
1
Set the MENU button to ON.
Press the MENU button to light its indicator.
2
Set the PRESET MEMORY/MENU 4 button
(AWB/ABB) to ON.
When the button is pressed and its indicator lights, the
[AWB/ABB] menu is displayed on the LCD panel.
3
Turn the F2 dial to select ABB, and press the
F2 dial.
A W B M O D :
S E T
The remote camera now automatically adjusts the black
balance.
When automatic adjustment is performed, the following
details are displayed on the LCD panel.
ABB ACTIVE:
This appears while ABB is being executed.
ABB OK:
This appears for 3 seconds after ABB was completed
successfully.
ABB NG:
This appears for 3 seconds after ABB was completed
unsuccessfully.
Note
The settings will differ depending on the remote camera
connected.
For further details, check the Operating Instructions of
the model concerned.
A W B B
: A B B
Manually adjusting the black balance
( Setting the R and B pedestal)
1
Connect a waveform monitor or colour monitor
to the video output connector on the currently
selected remote camera.
2
Set the MENU button to ON.
Press the MENU button to light its indicator.
3
Set the PRESET MEMORY/MENU 3 button
(R/BPED) to ON.
When the button is pressed and its indicator lights, the
[R/BPED] menu is displayed on the LCD panel.
4
Turn the F1 dial to select the R pedestal
setting; similarly, turn the F2 dial to select the
B pedestal setting.
R P E D
B P E D
Note
The settings will differ depending on the remote camera
connected.
For further details, check the Operating Instructions of
the model concerned.
11 (E)
: ± 0
F1 dial
: ± 0 F2 dial