Tire Inspection; Steering Handle Front Shock Absorbers Inspection - Sym XA05W4-EU Bedienungsanleitung

§TIRE INSPECTION §
 Tires should be checked and inflated with the engine shut off.
 If a tire's ground contacting curve is abnormal, check it with an air pressure gauge and inflate it to
the specified pressure.
 Tires pressure must be checked with an air pressure gauge when cold.
PLEASE REFER TO SPECIFICATIONS FOR STANDARD TIRE PRESSURE
Foreign materials
(nails or small
stones)
CAUTION:
 Abnormal tire pressure, wear, or crack is the most important cause that results in the loss control
of the steering handle and a punctured tire(s).
§STEERING HANDLE FRONT SHOCK ABSORBERS INSPECTION §

Perform this check with engine shut off and ignition switch
key removed.

Visual check front shock absorbers for damage.

Operate steering handle up and down, and check front
shock absorbers for noises due to bends.

Check the bolts and nuts of front shock absorbers with
wrenches for tightness.

Shake steering handle up & down, left & right, and front &
rear to check if it is loosen, has too much resistance and
pulls to one side.

Check steering handle if it is being pulled too tight by the
brake cables.

Take your motorcycle to SYM Authorized Dealer or
Franchised Dealer for a check or adjustment if any
abnormal conditions are found.

Visual check tires for frontal and lateral side walls
Crack and
for crack or damage.
damage

Visual check tires for any nails or small stones
wedged in the tread.
Check the "tread wear indicator" condition to see if

tread groove depth is insufficient.

A tire with a wear bar showing is worn out and
should be replaced immediately.
Tread wear
indicator
18