Inspection And Maintenance Before Riding; Routine Inspection; Engine Oil Inspection And Change - Sym XA05W4-EU Bedienungsanleitung

9. INSPECTION AND MAINTENANCE BEFORE RIDING

(Please refer to the components location diagram for the following components.)
§ROUTINE INSPECTION §
Check Items
Engine Oil
Fuel
Front
Brake
Rear
Front
Tires
Rear
Steering Handle
Speedometer, lights, and rearview
mirror
Tightness of Main Components
Abnormal Points
CAUTION:

If any problem founded during routine inspection, correct the problem before using the motorcycle
again, have your motorcycle checked and repaired by the "SYM dealer or authorized service
personnel" if necessary.
§ENGINE OIL INSPECTION AND CHANGE §
 INSPECTION:
1. Use the main parking stand to support the motorcycle
on a level ground, remove the dipstick after engine
stopped for 3~5 minutes. Wipe oil off the dipstick and
then insert it into the guide tube again (Do not rotate
it.)
2. Remove the dipstick and check whether oil level is in
between the upper and lower marks.
 Add oil to upper limit if oil is under the lower limit.
(Check cylinder, crankcase...etc for leakage.)
Is there enough engine oil?
Is it enough? Is it Octane 90 or above
Braking condition?
(Brake lever free play: 10~20mm)
Braking condition?
(Brake lever free play: 10~20mm)
Is tire pressure normal?
(Standard: 1.75kg/cm
Is tire pressure normal?
2
(Standard: 2.0 kg/cm
Does the handle vibrate abnormally or is difficult to turn?
Is it operated properly?
Do lights come on? Can it be seen clearly from behind?
Are screws, nuts loosen?
Do the previous troubles still exist?
13
Check Key Points
2
)
for 1 person, 2. 25 kg/cm
2
for 2 persons)