Inspection And Adjustment Of Brake Free Play; Disc Brake Inspection (Depending On Models) - Sym XA05W4-EU Bedienungsanleitung

§INSPECTION AND ADJUSTMENT OF BRAKE FREE PLAY§
INSPECTION: (Brake lever free play must checked with the engine shut off.)
 Brake lever and pedal free play for front and rear wheels.
◆If checking the hand-braking lever for front wheels, its free play (the stroke of hand-braking lever from
no braking to initial braking) should be 10~20mm. It is abnormal if the feel is spongy when holding the
hand-braking lever forcefully.
◆If checking the foot-braking pedal for rear wheels, its free play (the stroke of foot-braking pedal from
no braking to initial braking) should be 20~30mm. It is abnormal if the feel is spongy when press the
foot-braking pedal forcefully.
Adjustment:﹙Drum type﹚
 The indentation of brake adjustment nut must be aligned with the pin. (see below figure)
Adjustment nut
 Turn the adjustment nut on brake arm of front and rear wheels to adjust the free play of hand-brake
lever.
 Hold the hand-brake levers after adjusting with both hands until there is effective brake feeling.
 Measure the free play with a ruler.
Adjustment nut
10~20 mm
Rear Wheel hand-brake type
When free play is between 10~20 mm, check brake
indicators of front and rear wheels. If the arrow on
the brake arm aligned with the "△ " marked on the
brake disk, that means the brake lining has been
Pin
excessively worn, and must be replaced immediately.
Rear Wheel drum type
CAUTION:
To decrease
free play
To increase
free play
15