Advanced Programming - Dea ADVANCE Bedienungsanleitung Und Hinweise

8 ADVANCED PROGRAMMING

Below fi nd the description of some programming procedures relative to the management of the radio-commands memory and advan-
ced confi guration of the command inputs.
To access the control unit advanced programming functions, remove the Jumper J4 from the board. Use the
P005 and hold the
1 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the
P013;
2. Access the parameter by pressing the
3. The "Input Status" is shown on the screen (check that this is correct):
4. Press the button again;
5. The "Total Operation
(* see P064):
Ex: = 3x1000* = 3000 operations executed
6. Press the button again;
7. The "Maintenance Operation Counter" is shown on the screen (* see
P065):
Ex: = 5*x500 = 2500 operations still to be carried out before
the maintenance intervention request (
counter disabled)
8. Press the button again to exit the parameters (P013 is shown on the
screen again).
2 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Confi rm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fi x rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confi rm by pressing on the
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004) AFTER you have set the new encoding.
3 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire param-
eter (i.g. P032);
2. Confi rm by pressing on the
3. By pressing on
4. Confi rm by pressing on the
previously selected).
For the complete list of the "Operating Parameters" See the
table on page. 33.
26
key down for 5 seconds (at this point, all of the parameters are visible and can be modifi ed).
and keys until the screen reads
button;
Counter" is shown
= maintenance operation
and keys until you visualise
key;
and
key (display shows again P027).
key;
and , set up the desired value;
key (display shows the parameters
on the screen
keys:
and keys to go to