Product Description; Transport; Technical Data - Dea ADVANCE Bedienungsanleitung Und Hinweise

2 PRODUCT DESCRIPTION

2.1 Models and contents of the package
The name ADVANCE, identifi es a family of 24V electro-mechanical operators for the automation of hinged, up-and-over and sectional
doors. All motorised models use control units (NET series) that are equipped with anti-crushing sensor, incorporated 433 MHz radio
receiver, speed adjustment and deceleration on opening and closing.
ADVANCE models are specifi cally designed for semi-intensive residential use depending on the duty cycle envisaged for the automa-
tism.
The accompanying accessories are shown in the "PRODUCT ACCESSORIES" table (page 150).
ADVANCE is mainly composed of a mechanical operator that rotates a pinion which transmits motion directly to the drive of the door
via chain, thus allowing movement.
Inspect the "Content of the packaging" (Fig. 1) comparing it with your product; this may be useful during assembly.

2.2 Transport

ADVANCE is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all informa-
tion that may be provided on the same box for storage and handling.

3 TECHNICAL DATA

Motor power supply voltage (V)
Absorbed power (W)
Max Thrust (N)
Work cycle
Maximum n° of operations in 24
Operating temperature range (°C)
Opening speed (m/min)
Weight of product with package (Kg)
Protection degree
Power supply (V)
Rated power transformer (VA)
Fuse F1 (A)
24V operator output
Auxiliaries power supply output
Confi gurable Output 1
Confi gurable Output 2
Receiver frequency
Transmitters type of coding
Max remote controllers managed
20
OPERATOR
ADVANCE
24 V
20 cycles/hour
-20÷50 °C
CONTROL BOARD
NET724N
230 V ~ ±10% (50/60 Hz)
80 VA (230/22V)
T1A 250V (retarded)
max 5 A
24 V
24 V
24 V
433,92 MHz
HCS fi x-code - HCS rolling code - Dip-switch
120
500
60
5,3
13
IP20
max 200mA
max 5 W
max 5 W
100