Advanced Programming - Dea SPACE Bedienungsanleitung

7 ADVANCED PROGRAMMING

Below find the description of some programming procedures relative to the management of the radio-commands memory and advan-
ced configuration of the command inputs.
To access the control unit advanced programming functions, remove the Jumper J4 from the board. Use the
P005 and hold the key down for 5 seconds (at this point, all of the parameters are visible and can be modified).
1 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the
screen reads P013;
2. Access the parameter by pressing the
3. The "Input Status" is shown on the screen (check that this
is correct):
4. Press the button again;
5. The "Total Operation Counter"
screen followed by the
To calculate the number of completed operations, the two
values must be multiplied.
I.e.: = 120x10 = 1200 operations completed
6. Press the button again;
7. The "Total Maintenance Counter"
screen followed by the
To calculate the number of operations remaining before
the maintenance request, the two values must be
multiplied.
I.e.: = 1500x1 = 1500 operations yet to be
completed before the maintenance request
8. Press the button again to exit the parameters (P013 is
shown on the screen again).
2 Selection type of operators
1. Scroll down the parameters with
lise P028;
2. Access the parameter by pressing the
3. Acting on and
- d000 = SPACE
- d002 = SPACE XL
- d003 = SPACE XXL
4. Confirm your choice by pressing the
to P028).
36
and keys until the
button;
appears on the
multiplier.
appears on the
multiplier.
! IMPORTANT !
and keys until you visua-
key;
keys, set:
key (display returns again
and keys to go to