Restoring Default Parameters - Dea ADVANCE Bedienungsanleitung Und Hinweise

4 How to search and delete a transmitter
1. Scroll down the parameters until you visualize P006;
2. Confi rm by pressing on the
3. By pressing on and , keys, select the transmitter you
want to delete (eg. );
4. When " " fl ashes, confi rm the deletion by pressing
the key for a few seconds;
5. Release the key when appears "
6. The selected transmitter is deleted (display shows again
P006).

5 Restoring default parameters

WARNING At the end of the procedure, the display will be blocked on fl ashing "
again before any other operation can be carried out.
5.1 Restoring operating parameters
1. Scroll through the parameters with the buttons
until the display shows P007;
2. Confi rm by pressing on the
3. When " " is fl ashing, press the
seconds;
4. Release the key as soon as "
All the default values are restored except for the para-
meters from P016 to P022 and P076 to P098;
5. At the end of the operation display returns to P007.
Warning: After you restore the default parameters, you
must program the control panel again and adjust all ope-
rating parameters.
5.2 Restoring "I/O" setting (Input/Output)
1. Scroll through the parameters with the buttons
until the display shows P010;
2. Confi rm by pressing on the
3. When " " is fl ashing, press the
seconds;
4. Release the key as soon as "
All the default values only for the parameters from
P016 to P022 and from P076 to P098 are restored;
5. At the end of the operation display returns to P010.
6 Locking-Unlocking access to programming
By using a "dip-switch" remote (regardless of the type of remotes already memorized) it's possible to lock-unlock access to the program-
ming of the control panel to avoid tampering. The remote setting is the locking-unlocking code verifi ed by the control board.
6.1 Locking access to programming
1. Scroll through the parameters with the buttons
and until the display shows P008;
2. Access the parameter by pressing the button
3. The display shows alternately the writing
to indicate that the control board
is waiting for the transmission of the block code;
4. Within 10 seconds press CH1 on the "TX Master",
the display shows
to the list of parameters;
5. Access to programming is locked.
key;
";
and
key;
key for a few
" stops fl ashing;
and
key;
key for a few
" stops fl ashing;
;
before returning
" and motor stroke learning must be carried out
27