Symbol LS 9100 Kurzübersicht Seite 37

• ·Provide adequate clearance
• ·Provide a suitable working environment
• Improve work procedures.
Radio Frequency Interference Requirements - U.S.A.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Radio Frequency Interference Requirements - Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Marking and European Economic Area (EEA)
Products intended for sale within the European Union are marked with the CE Mark which indicates compliance
to applicable Directives and European Norme (EN).
Laser Devices
Symbol devices using lasers comply with US 21CFR1040.10, and IEC825-1:1993, EN60825-1:1994+A11:1996. The
laser classification is marked on one of the labels on the device.
Class 1 Laser devices are not considered to be hazardous when used for their intended purpose.
The following statement is required to comply with US and international regulations:
Caution: Use of controls, adjustments or performance of procedures other than those specified
herein may result in hazardous laser light exposure.
Class 2 and Class IIa laser scanners use a low power, visible light diode. As with any very bright
light source, such as the sun, the user should avoid staring directly into the light beam.
Momentary exposure to a Class 2 or Class IIa laser is not known to be harmful.
Power Supply
Note: Use only a Symbol-approved power supply (50-14000-009) output rated 5.2Vdc and minimum 0.65A. The
power supply is certified to EN60950 with SELV outputs.
Hinweis: Benutzen Sie nur eine Symbol Technologies genehmigt Stromversorgung (50-14000-009) in den Ausgabe:
5.2Vdc und minimum 0.65A. Die Stromversorgung ist bescheinigt nach EN60950 mit SELV Ausgaben
Marking and European Economic Area (EEA)
Products intended for sale within the European Union are marked with the CE Mark which indicates compliance
to applicable Directives and European Norme (EN).
Statement of Compliance
Symbol Technologies, Inc., hereby declares that this device is in compliance with all the applicable Directives, 89/
336/EEC, 73/23/EEC. A Declaration of Conformity may be obtained from http://www2.symbol.com/doc/
WARNINGThis is a Class A product. In a domestic environment this product may cause radio interference in
whichcase the user may be required to take adequate measures.
35