Problem Solving - Zodiac BARACUDA PACER Montage- Und Gebrauchsanleitung

2-Pacer ANG 0710.qxd 15/09/10
The Pacer does not work
The Pacer does not clean
all areas of the pool
The Pacer does not remain
on the bottom of the pool
The Pacer jams
at the pool steps
The Pacer moves very slowly
and air bubbles come out
of its outlet
The Pacer goes over
the water line
The Pacer jams on
the main drain
13:41 Page 9
1 6

6 / Problem solving

•
Check the flow using the flow tester optional
If the flow is insufficient:
•
Check that the valve of the main drain is closed.
•
Check that the pump pre filter and basket are clean.
•
Check that the hose and automatic adjustment valve are
correctly connected.
IMPORTANT:
Always check that the dark grey flap of the valve is not blocked
in the open position by the red lever – otherwise the pool cleaner
cannot operate.
If the water flow is correct:
•
Check that the cleaner suction inlet is not clogged up with debris.
•
Is the Pacer Diaphragm damaged?
•
In order to ensure complete cleaning of the pool, the total
filtering time may be split into several periods. For example,
6-hour filtration performed as 3 times 2 hours will provide better
coverage than a single 6-hour filtration.
•
Is your hose long enough: add hose sections if necessary.
•
Have you oriented all inlet jets downwards?
•
Is the hose in perfect condition?
•
Check the position of the hose weight.
•
Test the flow and increase it if necessary
•
Plug the hose in the suction point furthest from the steps.
•
Modify the hose length by adding or removing a section.
•
Orient the inlet jets so as to push the hose away from the steps.
•
Check the air tightness of the circuit: between all hose sections,
between the hose and the valve, between the valve and
the skimmer.
•
Reduce the flow
•
Close the main drain valve.
(see page 15).
(see page 15).
(see page 15).