BH FITNESS G6324 Montage- Und Gebrauchsanleitung Seite 16

ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(2) Main structure; (4L) side bar (left);
(4R) Side bar (right); (5) Monitor
support; (19) Monitor; (13) Allen screw
M-8x25; (30) Allen screw M-6x15; (39)
Safety key; Allen key 5mm; (305)
Allen key 6mm; (100) Bottle of
lubricant.
Follow the instructions step by step to
assemble:
1 First of all take the right side bar
(4R) connect terminals (17) (18) Fig.1,
then insert the side bar (4R) into the
bottom right-hand support on the
structure and use screws (13).
2 Now take the left side bar (4L) and
insert it into the bottom left-hand
support on the structure and use
screws (13) to secure it.
3 At least two people are needed for
this step. When fitting the side bars,
one person should hold the side bar
while the other one fits the screws
(13). This will prevent any possible
accidents.
Fig.B 4. ATTACHING THE MONITOR
TUBE.-
First of all, Fig.2, connect terminals
(33), coming out of the monitor tube,
with terminal (17), coming out of the
handrail. Now
connected terminals back inside the
monitor tubes (A), making sure not to
pinch any of the cables when inserting
these onto the handrail tubes in the
direction of the arrows. Now tighten
using screws (13).
5.- FITTING THE MONITOR:
Connect the control cable terminal
(140) Fig.3, coming out of the monitor,
to the control cable (17), sticking up
from the right-hand side bar (4R), and
insert screws (30), making sure not to
pinch the cables, and screw in until
hand tight.
Note:
Make sure that the cables do not
become caught up when the unit is
folded. Tighten the 4 screws (30) fully.
FOLDING YOUR UNIT.-
This treadmill is equipped with a
folding mechanism
purposes. To use it, stop the treadmill,
lower the elevation level to minimum,
unplug the mains cable and lift the unit
until you hear lever (9) click into place,
Fig.4. Store your unit in a dry place,
preferably not subject to changes in
temperature.
UNFOLDING YOUR UNIT.-
If you wish to use the treadmill, do the
reverse procedure. Use your to press
lever (9) in the direction of the arrow
as shown in Fig.4 and slowly lower the
treadmill belt down to the floor.
16
insert all of
for storage
the