Safety Instructions - BH FITNESS G6324 Montage- Und Gebrauchsanleitung

SAFETY INSTRUCTIONS.-

This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a plug
with an earth pin. The plug must only be
used with an appropriate wall socket,
installed correctly and connected to
earth, in accordance
regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug supplied
with the equipment, if it does not fit the
wall socket then get an electrician to
install an electrical socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig. A.
Make sure that the appliance is only
connected to a wall socket with the
same pin layout as the plug. Do not use
an adaptor with this appliance.
Always observe
recommendations when using electrical
appliances:
1 Make sure that the mains supply
voltage matches that of the machine
before plugging it in. The supply voltage
must be the same as that stated on the
with local
the following
characteristics plate and the holes in
wall socket must match the pins for plug
on the machine.
To reduce the risk of electrical shock,
2
first put the switch to the "0" position and
then unplug it from the wall socket.
Always unplug the unit immediately after
use and before proceeding to clean it.
3 Make sure that the treadmill is
switched off and unplugged before
beginning any type of maintenance or
assembly work on it.
4 Do not unplug the treadmill by tugging
on the mains cable.
5 Do not use the machine if the mains
cable becomes damaged or worn.
6 Keep the mains cable away from hot
surfaces.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This safety
automatically triggered if the unit is
subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Should the
repeatedly then the most probable
causes are:
-Abnormal working conditions,
-Treadmill belt in need of lubricant,
-Solvent based lubricants used,
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
15
device will
circuit breaker
be
trip