Panasonic AK-HC1800G Bedienungsanleitung Seite 11

Major operating controls and their functions
 When supplying DC power, supply the DC +1 V voltage to pin 6 and connect GND to
pin 8.
 Use the multi-cable provided with the AK-HRP150G when supplying power from the
AK-HRP150G.
 Use the cable provided with the AW-PH650 when supplying power from the AW-PH650.
 When supplying power from the AW-PH400, use the AW-CA15H9G or the
AW-CAK4H1G cable kit depending on the configuration of the control system.
 Use the AW-CA15H9G when supplying power from the AW-PH405.
 When supplying power separately, ensure that the specifications of the interface cable
given below are satisfied.
Interface cable specifications
Use a cable with a performance equivalent or superior to the specifications given below.
AK-HC1800G
(High-density D-sub 15-pin connector)
G/L GND
GND
DC power supply input
(+1 V)
Not used
Not used
G/L signal input
Not used
GND
DC GND
TX_N(EIA4)/
TXD(EIAC) output
GND
TX_P(EIA4) output
RX_N(EIA4)/
RXD(EIAC) input
GND
RX_P(EIA4) input
Connector: DHW10-15F00
made by Advanced Connectek Inc.
Cover: DE-C8-J9-F5-1R
made by Japan Aviation Electronics Industry, Ltd.
Cable length: 5 m or less
Cable length: 5 m or less
- 10 (E) -
DC GND
DC power supply input
(+1 V)
Power input: +12 V ±10 %,
5 A or more
G/L GND
G/L signal input
GND
RX_N(EIA4)/
RXD(EIAC) input
RX_P(EIA4) input
TX_N(EIA4)/
TXD(EIAC) output
TX_P(EIA4) output
 Use a twisted-pair cable.