Specifications; Additional Safety Rules - Makita JS1660 Betriebsanleitung

ENGLISH
1 Screw
2 Screwdriver
3 Center blade
4 Hex wrench

SPECIFICATIONS

Model
Max. cutting capacities
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Min. cutting radius ....................................................................... –
Strokes per minute ...................................................................... 4,500
Overall length .............................................................................. 304 mm
Net weight .................................................................................... 1.3 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed Safety
instructions.

ADDITIONAL SAFETY RULES

1. Hold the tool firmly.
2. Secure the workpiece firmly.
3. Keep hands away from moving parts.
4. Edges and chips of the workpiece are sharp.
Wear gloves. It is also recommended that you
put on thickly bottomed shoes to prevent injury.
5. Do not put the tool on the chips of the work-
piece. Otherwise it can cause damage and trou-
ble on the tool.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high loca-
tions.
8. Do not touch the blade or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
9. Avoid cutting electrical wires. It can cause seri-
ous accident by electric shock.
SAVE THESE INSTRUCTIONS.
Explanation of general view
5 Side blade
6 Bolt
7 Pin
8 Slide switch
2
............................................................. 1.6 mm/16 ga
2
............................................................. 1.2 mm/18 ga
2
............................................................. 0.8 mm/22 ga
2
..................................................... 2.5 mm/13 ga
JS1660
OPERATING INSTRUCTIONS
Adjusting the blade clearance (Fig. 1 & 2)
For JS1660 Only
Important: Always be sure that the tool is switched off
and unplugged before adjusting the blade clearance.
Adjust the clearance between the side blade and the
center blade according to the thickness of the workpiece.
First use a screwdriver to loosen the screw.
Then use the hex wrench to adjust the clearance by tight-
ening or loosening the bolt. There may be a slight differ-
ence between clearances (A) and (B).
Check the smaller clearance with the thickness gauge
and adjust it.
When using the thickness gauge to adjust the blade
clearance, refer to the table below.
ENB011-2
Workpiece thickness (mm)
Less than 0.8
0.8 – 1.3
More than 1.3
After adjusting the clearance, tighten the screw securely.
Lubrication (Fig. 3)
Before operation, lubricate the contact point of the center
blade and the pin. To keep good cutting performance,
also use a cutting lubricant from time to time during oper-
ation.
9 Limit mark
10 Brush holder cap
JS1670
1.0 mm/20 ga
0.7 mm/23 ga
0.5 mm/26 ga
2.5 mm/13 ga
30 mm
4,500
306 mm
1.3 kg
Marking on thickness
gauge
0.5
1.0
1.5
3