Troubleshooting; Troubleshooting The Sauna Heater; Spare Parts List - Tylo SENSE PLUS Gebrauchsanweisung

TROUBLESHOOTING

Troubleshooting the sauna heater

Table 1: Troubleshooting the sauna heater
Symptom Possible cause
Heater is not work- Main power switch
ing. is off.
Heater is not work- Fuse blown/tripped
ing.
Heater is not work- Temperature cut-out
ing. has been activated.
For more informa-
tion, see The sec-
tion called Temper-
ature cutfunction,
Page 5.
Temperature cutfunction
The sensor's temperature cut-out has the purpose of protecting
the components, tubular elements and woodwork in the sauna
from overheating. If the temperature cut-out is activated, the elec-
tricity supply to the control panel will be cut off. When the temper-
ature in the sauna cools down, it can be reset. The cause of the
overheating must be established before resetting the temperature
cut-out. To reset it, press the spring-loaded button with a small
implement such as a paper clip (see Figure 8, Page 5).
Figure 8: Resetting the sensor temperature cut-out

SPARE PARTS LIST

Remedy
Switch on.
Replace/reset fuse.
Check and remedy
the cause of tem-
perature cut-out ac-
tivation.
If you are unsure
why the temperat-
ure cut-out was ac-
tivated, contact an
electrician.
Figure 9: Spare parts
1.
2.
3.
4.
5.
6.
1
2
3
4
6
9600 0177 / 8 kW, 9600 0178 / 6 kW Tubular element
9600 0728 Stone compartment
9600 0091 Circuit board
9600 0723 Terminal block
9600 0041 Relay 3-pole
9600 0554 Strain relief connector
5
5