Battery Replacement - Tripp Lite OMNIVSX850D Bedienungsanleitung

Features
5
AC Power Input: Plug in a C14 power cord (OMNIVSX850/1000/1500 models) or use the
included 1.5 m power cord with Schuko plug (OMNIVS850D/1000D/1500D models) to connect
the UPS to the mains power source.
6
Resettable Input Circuit Breaker: Protects your electrical circuit from overcurrent draw
from the UPS load. If this breaker trips, remove some of the load, then reset by pressing it in.
Breaker is rated for 5A, 7A or 10A, 250V AC.
7
Variable-Speed Cooling Fan (OMNIVSX1500 and OMNIVSX1500D models only): This fan
regulates the internal temperature of the UPS.

Battery Replacement

Under normal conditions, the original battery in your UPS will last several years. Battery replacement
should only be performed by qualified personnel. Refer to "Battery Warnings" in the Important
Safety Instructions section for more information.
Models OMNIVSX850 and OMNIVSX850D require one 12V DC, 9Ah replacement battery.
Models OMNIVSX1000 and OMNIVSX1000D require one 12V DC, 9Ah replacement battery.
Models OMNIVSX1500 and OMNIVSX1500D require two 12V DC, 9Ah replacement batteries.
For further information about replacement compatibility and ordering, visit
www.tripplite.com/products/battery-finder.
Battery replacement must be done using the same battery type and
quantity: 12V DC sealed lead-acid, 6-cell and in compliance with UL 1989.
CAUTION: Risk of energy hazard. Before replacing batteries, remove conductive
jewelry such as chains, wristwatches and rings. High energy passing through
conductive materials may cause severe burns.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to instructions.
18-07-252-93388F.indb 9
9
10/3/2018 10:10:26 AM