Quick Installation - Tripp Lite OMNIVSX850D Bedienungsanleitung

Quick Installation

STEP 1: Plug the UPS into a properly grounded outlet.
After plugging the UPS into a wall outlet, press and hold the power button until a beep is heard, then
release to turn on the UPS.
Note: The UPS will not turn on automatically in the presence of live utility power.
OMNIVSX850/1000/1500
For illustrative purposes only.
User must supply power cord and plug
that is compatible with power outlets used in that region.
STEP 2: Plug your equipment into the UPS.
Outlets marked BATTERY & SURGE offer UPS battery backup support during power failures. Connect
your vital computer equipment into these outlets.
Your UPS is designed to support electronic equipment only. You will overload the UPS if the total
volt-amp (VA) ratings for all the equipment connected to the BATTERY/SURGE PROTECTED outlets
exceed the UPS output capacity. To find your equipment's VA ratings, look on their nameplates. If the
equipment is listed in amps (A), multiply the number of amps by 230 to determine VA. For example:
1A × 230 = 230VA. If you suspect you have overloaded the outlets, check Load Meter screens (see
Display UPS/Power Conditions in Basic Operation).
OMNIVSX1500 model shown. Number of outlets
and outlet layout may differ by model.
18-07-252-93388F.indb 4
Local
Utility
Power
Use the two included C14
to C13 cables to connect
equipment to the UPS.
Connected
Equipment
4
OMNIVS850D/1000D/1500D
OMNIVSX1500D model shown.
10/3/2018 10:10:23 AM