Protection Of Plastic Surfaces; Cleaning The Inner Surface; Stainless Steel Outer Surfaces; Cleaning Products With Glass Doors - Grundig GKN 3000 Carbon Bedienungsanleitung

6.2 Protection of plastic
surfaces
Do not put liquid oils or oil-
cooked meals in your refrigerator
in unsealed containers as they
damage the plastic surfaces of
your refrigerator. If oil is spilled or
smeared onto the plastic surfaces,
clean and rinse the relevant part
of the surface with warm water
immediately.

6.3 Cleaning the Inner Surface

To clean the inner surfaces and all
removable parts, wash them with
a mild solution comprising soap,
water and carbonate. Rinse and
dry thoroughly. Prevent the water
from contacting the lighting means
and control panel.
ATTENTION:
Do not use vinegar,
A
rubbing alcohol or
other alcohol-based
cleaning agents on any
of the inner surfaces.
6.4 Stainless Steel
Outer Surfaces
Use a stainless steel cleaning
agent that is non-abrasive and
apply it with a lint-free, soft cloth.
For polishing, wipe the surface
softly with a damp microfiber cloth
and use dry wash-leather. Always
follow the strands of the stainless
steel.
6.5Cleaning Products
with Glass Doors
Remove the protection foil on the
glass.
There is a coating on the
surface of the glass. This coating
minimises stain formation and
ensures that stains and dirt
are cleaned easily. Glasses that
are not protected by a coating
might be exposed to permanent
bonding of organic or inorganic, air
or waterborne pollutants such as
limescale, mineral salts, unburned
hydrocarbons, metal oxides an
silicons, which lead to stains and
physical damage in a short time.
Despite regular washing, the glass
becomes very hard to keep clean,
though not impossible. As a result,
the clarity and good appearance
of the glass reduces. Hard and
abrasive cleaning compounds and
methods increase these defects
even further and accelerate the
deterioration process.
*Non-alkali, non-abrasive and
water-based cleaning products
must be used for routing cleaning
procedures.
For the coating to have long service
life, alkali or abrasive substances
must not be used during cleaning
processes.
These glasses were subject to a
tempering process to increase
their impact and breakage
resistance.
As an additional safety measure,
there is a safety film on the
back surfaces of the glasses to
ensure that they will not harm the
environment in case of breakage.
33