Circor SR-3300 Einbau- Und Betriebsanleitung Seite 39

Einbau- und Betriebsanleitung
Installation and Operating instructions
4.5.2
Terminal Overview
4.5.2.1
Ground
4.
Ground must be done before operating the positioner.
5.
Open terminal cover and locate ground terminal plate on the right hand bottom side of the terminal plate. The outer
cable entry is located at outside of the terminal. Please make sure that the resistance is less than 100ohm.
6.
When using external ground, use (+) screw driver to unscrew the ground bolts.
5. Adjustments
5.1
Auto/Manual Switch (A/M Switch)
Auto/Manual Switch allows the positioner to be functioned as by-pass. If switch is set as Auto, the positioner will operate per
input signal. If switch is set as Manual, the positioner will send supply pressure directly to the actuator.
Positioner Terminal
IN +:
IN -:
FG:
OUT+:
OUT-:
Page 39
SR3300-8010
SR-3300
Input Signal (+)
Input Signal (-)
Ground
Feedback Signal (+)
Feedback Signal (-)
07/2018