Troubleshooting - Epson TM-P60II Benutzerhandbuch

3. Pull out some paper, close the cover, and tear off the paper with the manual
cutter.
Installing or Replacing Roll Paper Vertically
You can hang the printer vertically on a belt using a clip on the back of the printer.
When you use the printer vertically, follow the steps below to install the roll
paper.
Note:
Be sure that the roll paper end is on the bottom when you use the printer vertically.
1. Press the open button (E 14) to open the roll paper cover (E 15).
2. Remove the used roll paper core if there is one.
Set the new roll paper on the inside of the roll paper cover. See ➀ in illustration E.
3.
Note:
Note the direction the paper comes off the roll.
Pull the leading edge of the roll paper. See ➁ in illustration E.
4.
Align the left edge of the roll paper with the edge of the cover. See ➂ in
5.
illustration E.
6. Close the roll paper cover and tear off the paper with the manual cutter.
Changing the Paper Width
You can change the paper width from 58 mm to 60 mm by removing the spacer
installed in the roll paper holder and changing the setting for the paper width. For
detailed information on changing the paper width, see the TM-P60II Technical
Reference Guide.
Belt Clip
You can hang the printer on your belt using the belt clip (F 16) attached to the back
of the printer.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
❏
Remaining battery charge is not adequate
❏
Roll paper end
❏
Error

Troubleshooting

No lights on the control panel
Check that the battery is installed.
ERROR LED is flashing or on
❏
The printer temperature may be too high. The printer resumes printing
automatically when the temperature returns to normal.
❏
Make sure that the roll paper cover is properly closed.
❏
Make sure that roll paper is installed.
❏
When the printer power is on, if the Error LED and the Charge LED are on,
the remaining battery charge is not enough for printer operation. The battery
must be fully charged.
❏
When the battery is being charged, if the Error LED is on, an abnormality has
TM-P60II User's Manual 7
English