Installation; Points To Be Paid Attention To When The Relocation Of The Cooler/Freezer; Before You Start The Cooler/Freezer; Electrical Connection - Grundig GSMI 20310 Bedienungsanleitung

3

Installation

B
In case the information which are
given in the user manual are not taken
into account, manufacturer will not
assume any liability for this.
Points to be paid attention
to when the relocation of the
cooler/freezer
1. Your cooler/freezer should be
unplugged.Before transportation
of your cooler/freezer, it should be
emptied and cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside
your cooler/freezer should be fixed
with adhesive tape and secured
against impacts. Package should
be bound with a thick tape or
sound ropes and the
transportation rules on the
package should be strictly
observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the cooler/
freezer,
Check the following before you
start to use your cooler/freezer:
1. Clean the interior of the cooler/
freezer as recommended in the
"Maintenance and cleaning"
section.
2. Connect the plug of the cooler/
freezer to the wall socket. When
the fridge door is opened, fridge
internal lamp will turn on.
3. When the compressor starts to
operate, a sound will be heard.
The liquid and gases sealed within
the refrigeration system may also
give rise to noise, even if the
compressor is not running and this
is quite normal.
4. Front edges of the cooler/freezer may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your cooler/freezer
shall be guaranteed only if the earth
system in your house complies with
standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
• Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is the risk of
electric shock!
8
EN