F3.5: 1St Voice Effect Depth; F3.6: 2Nd Voice Effect Depth; F3.7: (Clp-511) Slow-Attack Strings; F3.7: (Clp-411), F3.8: (Clp-511) Reset - Yamaha Clavinova CLP-411 Bedienungsanleitung

F4
(CLP-511) Split Mode Functions
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

F3.5: 1st Voice Effect Depth

F3.6: 2nd Voice Effect Depth

These functions make it possible to individually set the depth of the chorus effect for the
1st and 2nd dual-mode voices ("1st" and "2nd" refer to the left and right voice selectors,
respectively). Use the [–/NO] and [+/YES] buttons to set the effect depth for the correspond-
ing voice as required. The depth range is from 0 through 20. A setting of "0" produces no
effect, while a setting of "20" produces maximum effect depth. Press the [–/NO] and [+/YES]
buttons simultaneously to recall the default setting (the default effect depth setting is different
for each voice).
• The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be
NOTE
exited before EFFECT can be turned ON.

F3.7: (CLP-511) Slow-attack Strings

In a dual mode voice combination using a strings voice and any other voice, a better
"blend" can sometimes be produced by switching the strings voice to a slow-attack variation.
Use the [–/NO] and [+/YES] buttons to turn the slow-attack variation "On" or "OFF", as
required. Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting:
"OFF".

F3.7: (CLP-411), F3.8: (CLP-511) Reset

This function resets all dual-mode functions to their default values. Press the [+/YES]
button to reset the values. "End" will appear on the display when all functions have been
reset.
After selecting "F4. Y ", press the [+/YES] button to engage the split-mode function sub-
mode, then use the [<] and [>] buttons to select the desired split mode function, as listed
below.
If the Split mode is not engaged "F4. - " will appear instead of "F4. Y " and the Split mode
functions cannot be selected. Also note that you must exit from the Function mode before the
Split mode can be engaged.
SHORTCUT: You can jump directly to the split-mode functions (F4) by pressing the
[FUNCTION] button while holding the [SPLIT] button.

F4.1: Split Point

............................................................................................................................................
In addition to the split point setting method described on page 11, the split point can be set
via this function. Use the [–/NO] and [+/YES] buttons to set the split point as required, or
simply press the appropriate key on the keyboard: from "A-1" to "C7". Press the [–/NO] and
[+/YES] buttons simultaneously to recall the default setting: "F#2".
............................................................................................................
..........................................................................................................
......................................................................................
...............................................................................
The Function Mode
23