Remote Control Functions - Dirna miniCOOL COMPACT 3.0 Benutzerhandbuch

EN
F6 Function: ºF Selection
To activate this function, keep the ON/OFF
then release the key to directly enable ºF. To return to ºC, keep the
pressed down with the display flashing C
the control panel. The control is disabled when carrying out this operation, meaning it must be
registered again once finished.
Remote control

Remote Control Functions:

1
Unit On / Off
Note: when this Key is pushed, the unit starts in
automatic mode F4 / P4
2
Blower speed control (manual mode only)
Note: while the unit is working in automatic mode F4 / P4, if the
user press this key, the unit will change the working mode to manual
F0 / P0. This allows the user to choose the desired air flow by
pushing this key and the following symbols will appear on the
display: V1, V2, V3, V4, V5, V4, V3, V2, V1
3
Temperature control
The comfort temperature is controlled by briefly pressing the + / -
(15/ 27 ºC
keys
To release the remote control:
To release the remote control; with the unit stopped, keep pushed the key
panel. The symbol C
the On/ Off key before 30 seconds and the unit will emit an acoustic signal. In case this does not
happen, this operation will need to be repeated from the beginning.
).
- 59/80º F
will appear blinking in the display. When this symbol stops blinking, push
key pressed down until the display shows F6, and
, when it stops flashing, press the
10
key on the control panel
1
2
.
from the control
key on
3