Functional Description; Operation - Makita TW0350 Bedienungsanleitung

WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
Fig.1
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Change the direction of rotation only when the tool
•
comes to a complete stop. Changing it before the
tool stops may damage the tool.
The switch is reversible, providing either clockwise or
counterclockwise rotation. To start the tool, simply pull
the lower part of the switch trigger for clockwise or the
upper part for counterclockwise. Release the switch
trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
Installing or removing socket
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the socket.
Fig.2
For socket without O-ring and pin
To install the socket, push it onto the anvil of the tool until
it locks into place.
To remove the socket, simply pull it off.
For socket with O-ring and pin
Fig.3
Move the O-ring out of the groove in the socket and
remove the pin from the socket. Fit the socket onto the
anvil of the tool so that the hole in the socket is aligned
with the hole in the anvil. Insert the pin through the hole
in the socket and anvil. Then return the O-ring to the
original position in the socket groove to retain the pin. To
remove the socket, follow the installation procedures in
reverse.

OPERATION

The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
300
250
200
150
100
M12X80
(1/2"X3-1/8")
50
0
0.5 1
1.5
Fastening time (S)
004009
High tensile bolt
300
250
M16(F10T)
(5/8")
200
M12X80
150
(1/2"X3-1/8")
100
50
0
1 2 3
Fastening time (S)
004010
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
NOTE:
When fastening screw M12 or smaller, carefully
•
adjust pressure on the switch so that the screw is
not damaged.
Hold the tool pointed straight at the bolt or nut
•
without applying excessive pressure on the tool.
4
M20X80
(3/4"X3-1/8")
M16X80
(5/8"X3-1/8")
2 3
2.5
M16
(5/8")
M12
(1/2")
4 5 6