Additional Information; Troubleshooting - Pioneer VSX-LX 70 Bedienungsanleitung

Additional information

Chapter 5:
Additional information

Troubleshooting

Refer to the following information if you come up with a problem. Operational mistakes may be misunderstood as
mechanical problems. Also, the cause of a problem may lie elsewhere other than this receiver. Check your audio
components on the network as well as your USB memory device. If problems persist or if the following information
does not provide you with an appropriate remedy, consult with your nearest Pioneer service center.
Symptoms Causes
Cannot access the network. The LAN cable is not firmly connected.
The router is not switched on.
Internet security software is currently installed in
the connected component.
The audio component on the network which has
been switched off is switched on.
Playback does not start The component is currently disconnected from
while 'Connecting...' this receiver or the power supply.
continues to be displayed.
The PC or Internet radio is The corresponding IP address is not properly set. Switch on the built-in DHCP server function of
not properly operated.
The IP address is being automatically
configured.
The audio files stored on Windows Media Player 11 is not currently
components on the network, installed on your PC.
such as a PC, cannot be
Audio files were recorded in formats other than
played back.
MP3, WAV (LPCM only), MPEG-4 AAC, FLAC,
and WMA.
Audio files recorded in MPEG-4 AAC or FLAC are
being played back on Windows Media Player 11
or Windows Media Connect.
The component connected to the network is not
properly operated.
The component connected to the network does
not permit file sharing.
The folder stored on the component connected
to the network has been deleted or damaged.
Cannot access the The component connected to the network is not
component connected to properly set.
the network.
There are no playable audio files on the
component connected to the network.
Remedies
Firmly connect the LAN cable.
Switch on the router.
There are cases where a component with
Internet security software installed cannot be
accessed.
Switch on the audio component on the network
before switching on this receiver.
Check whether the component is properly
connected to this receiver or the power supply.
your router, or set up the network manually
according to your network environment.
The automatic configuration process takes time.
Please wait.
Install Windows Media Player 11 on your PC.
Play back audio files recorded in MP3, WAV
(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
that some audio files recorded in these formats
may not be played back on this receiver.
Audio files recorded in MPEG-4 AAC or FLAC
cannot be played back on Windows Media Player
11 or Windows Media Connect. Try using
another server.
Check whether the component is affected by
special circumstances or is in the sleep mode.
Try rebooting the component if necessary.
Try changing the settings for the component
connected to the network.
Check the folder stored on the component
connected to the network.
If the client is automatically authorized, you need
to enter the corresponding information again.
Check whether the connection status is set to
"Do not authorize".
Check the audio files stored on the component
connected to the network.
05
Refer to
3
—
—
—
—
10
—
4
—
Refer to the
operation
manual
supplied
with your
server.
—
—
—
—
—
13
En