Truck Requirements; Recommended Hydraulic Supply - Cascade 6077298-R4 Bedienungsanleitung

I
NSTALLATION

Truck Requirements

Truck Relief Setting
2200 psi (152 bar) Recommended
3500 psi (241 bar) Maximum
Truck Flow Volume
35K, 55K
70K
➀ Cascade K-Series Integral Fork Positioner/Sideshifters are
compatible with SAE 10W petroleum base hydraulic fluid
meeting Mil. Spec. MIL-0-5606 or MIL-0-2104B. Use of synthetic
or aqueous base hydraulic fluid is not recommended. If fire
resistant hydraulic fluid is required, special seals must be used.
Contact Cascade.
➁ Flow less than recommended will result in slow fork positioning
speed.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Auxiliary Valve Functions
Check for compliance with
ITA (ISO) standards:

Recommended Hydraulic Supply

6
➀
Min. ➁ Recommended Max.
1 GPM 2 GPM
(4 L/min.) (7.5 L/min.)
FP0869.eps
➂
3 GPM
(12 L/min.)
Hoist Down
Hoist Up
GA0425.eps
Tilt Back
Fork Positioning function: No. 3 hose/No. 4 fittings
with 5/32-in (4 mm) minimum I.D.
Sideshifting function: No. 4 hose/No. 6 fittings with
3/16-in. (5 mm) minimum I.D.
Refer to Cascade Hose & Cable Reel Selection Guide,
Part No. 212199 to select the correct hose reel for the
mast and truck.
A
Fork Positioning / Sideshifting
A Mast Double Internal Reeving
B,C
OR
B Mast Single Internal Reeving with RF
Hydraulic Control
OR
C Mast Single Internal Reeving with electrical
cable and attachment mounted solenoid
valve
Tilt Sideshift
Forward
Left
Open/Spread Forks
Close Forks
Sideshift Right
6077298-R4 EN
FP0865.eps