Cascade 6077298-R4 Bedienungsanleitung Seite 14

I
NSTALLATION
11
Adjust forks for equal movement
(if required)
NOTE: Attachment is factory adjusted for equal
fork movement when operated at recommended
pressure and flow rate.
A
Locate flow restrictors at each end. Loosen
jam nuts and screw both flow restrictors in
until they bottom. Screw each restrictor out
(CCW) 1/2 turn.
B
Open forks fully, then close. Look for unequal
fork movement.
C
On faster fork (one that bottoms first), screw
flow restrictor in (CW) 1/4 turn.
D
Repeat Steps B and C until fork movement is
equal. Tighten jam nuts.
12
Inspect fork hooks,
carriage bar clearance
NOTE: Use go/no-go Wear Gauge Part No.
209560 (Class II) or 209561 (Class III).
A
Inspect the fork lower hooks and carriage
bar. If the gauge fits between the carriage
bar and lower hook, repair or replacement is
needed.
B
Inspect the upper carriage bar. If the gauge
arrow touches the carriage bar, repair or
replacement is needed.
C
Inspect the fork upper hooks. If the
gauge arrow touches the hook, repair or
replacement is needed.
12
FP0760.eps
A
Back (Driver's) View
FORK LOWER HOOKS, CARRIAGE
Wear
Gauge
UPPER CARRIAGE BAR
FORK UPPER HOOKS
Flow Restrictor
(each side)
FP0832.eps
6077298-R4 EN