Special Definitions - Cascade 6077298-R4 Bedienungsanleitung

I
NTRODUCTION
This manual is for the Cascade K-Series Integral Fork
Positioner & Sideshifter. Contents include an Operator's
Guide, Installation Instructions, Periodic Maintenance and
Recommended Spare Parts. All specifications are shown
in U.S. and (Metric) units where applicable.
IMPORTANT: K-Series Integral Fork Positioner &
Sideshifter is metric. Supply fittings adapted as required
for application.

Special Definitions

The statements shown appear throughout this Manual
where special emphasis is required. Read all WARNINGS
and CAUTIONS before proceeding with any work.
Statements labeled IMPORTANT and NOTE are provided
as additional information of special significance or to make
the job easier.
WARNING – A statement preceded by
WARNING is information that should be
acted upon to prevent bodily injury. A
WARNING is always inside a ruled box.
CAUTION – A statement preceded by CAUTION is
information that should be acted upon to prevent
machine damage.
IMPORTANT – A statement preceded by IMPORTANT is
information that possesses special significance.
NOTE – A statement preceded by NOTE is information that
is handy to know and may make the job easier.
O
PERATION
This section contains operating instructions for the
Cascade K-Series Integral Fork Positioner & Sideshifter.
It will help you avoid common errors which often cause
damage to the equipment or product being handled.
This information is intended to simplify operator
understanding about effective and safe Fork Positioner
& Sideshifter use and operation. Read this information
thoroughly before operating the attachment. Be sure you
know and understand all operating procedures and safety
precautions. If you have any questions or don't understand
a procedure, ask your supervisor.
Emphasize Safety! Most accidents are caused by
operator carelessness or misjudgment. You must
watch for poorly maintained equipment and
hazardous situations and correct them.
6077298-R4 EN
WARNING: Rated capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than shown on the attachment
nameplate. Consult the truck nameplate.
WARNING: Do not operate this attachment
unless you are a trained and authorized lift
truck driver.
WARNING: Usable fork length must not
exceed 60 in. (1500 mm).
Backrest
Sideshifter
Fork
Positioner
FP0863.eps
Integral
Carriage
Forks
1